You can now enable expert mode for your printer. This will make it possible to print raw g-code on your Sculpto 3D printer. When enabled it cannot be disabled and we will always be able to see that you have enabled expert mode.
PLEASE NOTICE THAT WE STRONGLY ADVISE AGAINST ENABLING EXPERT MODE SINCE USING IT CAN SEVERELY DAMAGE YOUR PRINTER. PLEASE READ THE TERMS AND CONDITIONS CAREFULLY.
When you print g-code using expert mode the printer automatically heats up and running the start sequence like you know from printing your own STL or when printing a model from the app. This heats the hot-end to 200 degrees Celsius and then the start sequence begins with the probing of the print bed and extruding in the perimeter of the build plate. This means that we have injected the offsets that is unique to your printer and you don’t have to worry about the offsets when printing your own g-code. After the start sequence it will automatically start printing the g-code that you have uploaded to your printer. Please be very careful where you place center in your slicer and the size of the buildplate. We cannot advice on this since it is different from slicer to slicer. The build space is 20 centimeters in diameter and 16 centimeters in height.
If you wish to enable expert mode please go to https://app.sculpto.dk/#!/expert. Please make sure to be logged into the web-app with the user that owns the printer you wish to enable expert mode on otherwise you will not be able to proceed.